I have two wireless router, the original with a single time, sometimes can not receive wireless signal upstairs to see if the instructions, we can use these two to do a bridge (Bridge), a release F Under the upstairs as a gateway to use, so that the signal will not be upstairs, downstairs existence of a problem!

First of all, you have to get the MAC address of two routes


What? How to enter the router the management contact surface? Collapse. . . One look at TP-LINK the instruction booklet. . . the next step is a key, first map-read:


Open the wireless parameter of this configuration page, check the "Start Bridge feature" in the AP1's MAC address of this column enter inside the MAC address of another route! And then to another router, fill out the routing of the MAC address of the station to the AP1 in this one. . .

Thus, basically completed! In addition, it is necessary to change what another router gateway address can not both use 192.168.1.1, which does not change as a gateway which Taiwan 192.168.1.X (2 <X <255), the final , it is best to manually configure the TCP / IP, the gateway address is 192.168.1.1. . .

Basically clear! Hei hei! The final step is a wireless encryption, this depends on the instruction manual, and I have these two are the TD-89541G, there are instructions for the encryption method, you will appreciate their look up!

Here is TP-LINK function on the description on the Bridge:
QUOTE： Open the Bridge Function: This function allows to open multiple wireless connectivity between wireless router to achieve the expansion of wireless network coverage purposes. Interconnection of the two wireless devices (wireless router or AP) between the recognition by MAC address. In other words, they must know each other's MAC address, otherwise it is impossible to interconnect. AP1 ~ AP6's MAC address: Enter the device you want to interconnect with the target device (wireless router or AP) of the MAC address. Enter up to six MAC address of value, which is a wireless device also can connect up to six wireless AP or wireless router.

For example: wireless devices A (MAC address 00-03-7F-BE-F0-E8) and wireless devices you want to B (MAC address 00-03-7F-BE-F0-E1) for wireless interconnection, it would take The following diagram configured in accordance with A equipment; the same time, device B should also be configured accordingly. Configuration is completed, the two can be interconnected wirelessly.

Open the Security Settings: To provide security for wireless data transmission control, you can select the point and as described in accordance with the following set the security configuration. Security Type: The router will provide a total of three different security types, in different security types, security settings for different items. Details see below.

Note: Bridge mode, the router only supports WEP security types.